Professional Dehydrator TEPLOCERAMIC FD8000 for 32-72 kg of Jerky, Fruits, Vegetables, and Mushrooms

TEPLOCERAMIC
FD8000
2999,00
3199,00
The TEPLOCERAMIC FD8000 dehydrator is a professional model drying cabinet with the following ADVANTAGES:

  • High productivity - the total tray area is 8.0m² (loading for thinly sliced meat for Jerky is 32 kg, and varies for other products depending on their weight and slice thickness).
  • Two completely separate sections with 16 trays each (with separate doors and no air exchange between sections) allow drying with less simultaneous loading or drying different products.
  • Both the body and the trays are made entirely of Food Grade AISI 304 Stainless Steel.
  • Energy efficiency of the dryer is achieved as follows: The power of the heating elements in each section is 1.5kW and for the dryer as a whole is 3kW. Each section can be turned on separately or both together. The fans run all the time but consume very little electricity, and the heating elements only operate when the temperature in the dryer drops below the set point. Jerky meat dries in about 8 hours with low electricity costs. Even if drying apple chips, which dry for about 18 hours at 70°C, the average consumption is 1kW per hour per section or 2kW per hour for both sections, so the total dryer uses only 36kW per cycle for drying apple chips.
  • Moist air is not expelled into the room but into a 100mm duct (can be connected to an extractor or vent duct).
  • Reinforced trays made of 4mm thick rods and 6x6mm mesh, 1mm thick. In tests with a uniform load of 10kg on the tray, it only bent by 7mm.
  • Reinforced body on wheels with an internal frame to handle heavy loads.
  • Convenient body dimensions: only 54 cm wide (can be carried through any door), with overall dimensions of 54 x 72 x 176 cm, similar in size to a modern domestic refrigerator and does not take up much space in the room.
  • The dehydrator uses 495x495mm trays, the same size used in other popular models such as FD2500, FD5000, ensuring convenience if you plan to combine several of our dryers in operation.
  • Separate drying settings for the upper and lower sections of the dehydrator. Drying time can be set from 30 minutes to 96 hours, and drying temperature from 30°C to 75°C.
  • The dryer has power-independent memory and will resume drying from the same place where it stopped after power loss and restoration.
  • The dehydrator has a "dry state maintenance" mode and can continue to ventilate the drying chambers with air at a temperature of 30°C until the operator decides to stop the dryer. This is very important because the dryer may finish working during non-working hours and products must not reabsorb moisture. This mode is recommended for cooling and during the gradual unloading of the dryer and simultaneous packing so your products are guaranteed to be packed dry.
  • Ease of service is provided by easy access for removal and replacement of all main components (fans, heating elements, control boards, buttons, and switches). After the warranty period, you do not have to send the entire dryer for repair or call a technician; anyone with a screwdriver can replace all the main components themselves, or remove them and send them for repair to our service center.

With this dehydrator, you can quickly and efficiently produce:
  • Apple, orange, banana, or persimmon chips
  • Jerky or Kabanos
  • Fruit leather
  • Yogurt candies
  • Flaxseed-based flatbreads
  • Dried mushrooms, vegetables, nuts, and many other products.

Decide and try!

Design Features: 2 separate chambers + exhaust

Power, W: 3000

Dimensions (cm): 54 х 74 х 176

Material: Stainless steel 304

Drying area (m²): 8

Number of trays: 32

Control Type: Digital controller

Color: Stainless steel

Tray dimensions (cm): 50 х 50

Loading volume (kg): 32-72

Volume of the drying chamber (l): 360

OTHER POPULAR MODELS